收藏本站
Si4464/63/61/60
6. Program the RSSI threshold property in the modem using “MODEM_RSSI_THRESH”.
7. Set the preamble threshold using “PREAMBLE_CONFIG_STD_1”.
8. Program the preamble timeout property using “PREAMBLE_CONFIG_STD_2”.
9. Set the sync detection parameters if enabled.
10. If needed, use “GPIO_PIN_CFG” to configure a GPIO to toggle on hop and hop table wrap.
11. Use the “START_RX” API with channel number set to the first valid entry in the hop table (i.e., the first non
0xFF entry).
12. Device should now be in auto hop mode.
5.3.1.3. Manual RX Hopping
The RX_HOP command provides the fastest method for hopping from RX to RX but it requires more overhead and
management by the host MCU. Using the RX_HOP command, the turn-around time is 75 μs. The timing is faster
with this method than Start_RX or RX hopping because one of the calculations required for the synthesizer
calibrations is offloaded to the host and must be calculated/stored by the host, VCO_CNT0. For information about
using fast manual hopping, contact customer support.
5.4. Transmitter (TX)
The Si4464/63 contains an integrated +20 dBm transmitter or power amplifier that is capable of transmitting from
–20 to +20 dBm. The output power steps are less than 0.25 dB within 6 dB of max power but become larger and
more non-linear close to minimum output power. The Si4464/63 PA is designed to provide the highest efficiency
and lowest current consumption possible. The Si4461 PA is capable of transmitting from –40 to +16 dBm. The
Si4461 PA can be optimized for either optimum current consumption (Class E) or for fine output power steps and
performance over voltage and temperature (switched-current). Switched-current matching will have fine output
power steps and more constant output power over VDD, but it will have higher current consumption than the
class-E matching. The class E will have the most efficient current consumption, but it will have more coarse output
power steps and variation across VDD. The Si4460 is designed to supply +10 dBm output power for less than
20 mA for applications that require operation from a single coin cell battery. The Si4460 can also operate with
either class-E or switched current matching and output up to +13 dBm Tx power. All PA options are single-ended to
allow for easy antenna matching and low BOM cost. Automatic ramp-up and ramp-down is automatically
performed to reduce unwanted spectral spreading.
Chip’s TXRAMP pin is disabled by default to save current in cases where on-chip PA will be able to drive the
antenna. In cases where on-chip PA will drive the external PA, and the external PA needs a ramping signal,
TXRAMP is the signal to use. To enable TXRAMP, set the API Property PA_MODE[7] = 1. TXRAMP will start to
ramp up, and ramp down at the SAME time as the internal on-chip PA ramps up/down.
The ramping speed is programmed by TC[3:0] in the PA_RAMP_EX API property, which has the following
characteristics:
34
TC
0.0
1.0
2.0
3.0
4.0
5.0
6.0
7.0
8.0
Ramp Time (μs)
2.0
2.1
2.2
2.4
2.6
2.8
3.1
3.4
3.7
Rev 1.2
发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

*型号 *数量 厂商 批号 封装
添加更多采购

我的联系方式

*
*
*
相关PDF资料
SI4465ADY-T1-GE3 MOSFET P-CH 8V 13.7A 8SOIC
SI4466DY-T1-GE3 MOSFET N-CH 20V 9.5A 8-SOIC
SI4470EY-T1-GE3 MOSFET N-CH D-S 60V 8-SOIC
SI4472DY-T1-GE3 MOSFET N-CH D-S 150V 8-SOIC
SI4477DY-T1-GE3 MOSFET P-CH D-S 20V 8-SOIC
SI4483EDY-T1-GE3 MOSFET P-CH D-S 30V 8-SOIC
SI4484EY-T1-GE3 MOSFET N-CH 100V 8-SOIC
SI4488DY-T1-GE3 MOSFET N-CH 150V 8-SOIC
相关代理商/技术参数
SI4463-915-PDK 制造商:Silicon Laboratories Inc 功能描述:KIT DEV WIRELESS SI4463 915MHZ
Si4463-B0B-FM 功能描述:射频收发器 TRX ROM 63 EZRadioPRO RoHS:否 制造商:Atmel 频率范围:2322 MHz to 2527 MHz 最大数据速率:2000 Kbps 调制格式:OQPSK 输出功率:4 dBm 类型: 工作电源电压:1.8 V to 3.6 V 最大工作温度:+ 85 C 接口类型:SPI 封装 / 箱体:QFN-32 封装:Tray
Si4463-B0B-FMR 功能描述:射频收发器 TRX ROM 63 EZRadioPRO RoHS:否 制造商:Atmel 频率范围:2322 MHz to 2527 MHz 最大数据速率:2000 Kbps 调制格式:OQPSK 输出功率:4 dBm 类型: 工作电源电压:1.8 V to 3.6 V 最大工作温度:+ 85 C 接口类型:SPI 封装 / 箱体:QFN-32 封装:Tray
SI4463B1BFM 制造商:Silicon Laboratories Inc 功能描述:
Si4463-B1B-FM 功能描述:射频收发器 TRX RoHS:否 制造商:Atmel 频率范围:2322 MHz to 2527 MHz 最大数据速率:2000 Kbps 调制格式:OQPSK 输出功率:4 dBm 类型: 工作电源电压:1.8 V to 3.6 V 最大工作温度:+ 85 C 接口类型:SPI 封装 / 箱体:QFN-32 封装:Tray
Si4463-B1B-FMR 功能描述:射频收发器 TRX RoHS:否 制造商:Atmel 频率范围:2322 MHz to 2527 MHz 最大数据速率:2000 Kbps 调制格式:OQPSK 输出功率:4 dBm 类型: 工作电源电压:1.8 V to 3.6 V 最大工作温度:+ 85 C 接口类型:SPI 封装 / 箱体:QFN-32 封装:Tray
SI4463BDY 制造商:VISHAY 制造商全称:Vishay Siliconix 功能描述:P-Channel 2.5-V (G-S) MOSFET
SI4463BDY-E3 制造商:VISHAY 制造商全称:Vishay Siliconix 功能描述:P-Channel 2.5-V (G-S) MOSFET